Home » Mark-Costello’s Side-Eject vs. Conventional End-Eject Balers
Mark-Costello’s Side-Eject vs. Conventional End-Eject Balers
Step |
Mark-Costello Side-Eject |
Conventional End-Eject |
1 |
Feed Material |
Insert front end of wire ties |
2 |
Fill until “bale made” signal |
Feed Material |
3 |
Insert wire and tie off |
Fill until “bale made” signal |
4 |
Depress “home” button |
Insert rear end of wire ties |
5 |
Open door |
Walk behind to tie bale |
6 |
Eject bale w/eject switch |
Feed front wire ties for next bale |
7 |
Lift bale with forklift |
Open door |
8 |
Retract server island |
Engage “flag pole” gauge |
9 |
Close door and repeat |
Feed next bale to push out bale |
10 |
|
Retract “flag pole” |
11 |
6 |
Extract wedged bale from chamber |
12 |
Fewer |
Lift bale with forklift, etc. |
13 |
Steps! |
Clean up spillage |
14 |
|
Adjust wire on loose bale |
15 |
|
Close door and repeat |